# Hardware validation ## Confirmed on 2026-09-23 Version 0.2.1 was installed and the systemd user watcher restarted on the following setup: | Component | Tested configuration | | --- | --- | | Desktop | Arch Linux, Hyprland 0.56.2 | | Configuration provider | Lua (`hyprctl -j status`) | | Session | Local Wayland session on seat0, graphical VT1 | | Display | iiyama PL3288UH, 3840 × 2160 at 60 Hz | | Output | `HDMI-A-2` | | Timing | 5 s HDMI settle, 1 s temporary VT, 2 s return settle, 30 s cooldown | The original failure was reproduced: legacy DPMS/focus commands returned Lua syntax errors and stopped recovery before the VT switch. Both corrected Lua commands returned `ok` on the running compositor. After installation, a complete manual recovery returned to graphical VT1 and reported: ```text revive-monitor-fix: Recovery started for HDMI-A-2 on VT 1 revive-monitor-fix: Using lua dispatch syntax revive-monitor-fix: VT refresh: 2 -> 1 revive-monitor-fix: Recovery completed for HDMI-A-2 ``` The watcher remained active. The operator then tested physical HDMI input switching and confirmed that recovery worked successfully. ## Automated validation - All 30 behavioral tests passed, including Lua and legacy dispatch syntax, refresh failures, session guards, VT return handling and installer behavior. - Bash syntax checks and ShellCheck 0.11.0 passed. - Installer archive and ZIP contents matched; ZIP integrity, Base64 round-trip and release checksums were verified. ## Scope and remaining checks This confirms the normal HDMI input-switch path on the setup above. It does not establish compatibility with every monitor or GPU. The operator had reported that the earlier unwanted tty switching was gone. A dedicated cold-boot/pre-login check and logout/login cycle after the 0.2.1 update have not been separately confirmed. Rapid away/back switching inside the cooldown also remains a separate test; such events can be suppressed by design. See [the hardware acceptance procedure](troubleshooting.md#hardware-acceptance).